User's Manual

Hardware Description
1-3
Wi-Fi Phone Cradle
The access point accepts a Wi-Fi Phone in its cradle for charging the battery. When
the access point is powered on, just place the phone in the cradle and charging
starts immediately.
LED Indicators
The access point includes three status LED indicators, as described in the following
figure and table.
Ethernet Port
The access point has one 10BASE-T/100BASE-TX RJ-45 port that can be attached
directly to 10BASE-T/100BASE-TX LAN segments. These segments must conform
to the IEEE 802.3-2005 specifications.
This port supports automatic MDI/MDI-X operation, so you can use straight-through
cables for all network connections to PCs, switches, or hubs.
LED Status Description
PWR/SEATED On Green Indicates that the system is working normally.
On Red The system is working normally with a Wi-Fi phone seated in the
cradle.
WLAN On/Flashing Green Indicates the 802.11g radio is enabled and transmitting or
receiving data through wireless links. The flashing rate is
proportional to network activity.
Off Indicates the 802.11g radio is disabled.
LAN On/Flashing Green Indicates a valid link on the Ethernet port and that the access
point is transmitting or receiving data. The flashing rate is
proportional to network activity.
Off The Ethernet port has no valid link.
W
LAN
LAN
Power
802.11g
Wireless
Link/Activity
Ethernet
Link/Activity