User's Manual
Table Of Contents
- Compliances
- About This Guide
- Contents
- Figures
- Tables
- Index of CLI Commands
- Getting Started
- Introduction
- Network Topologies
- Installing the access point
- Initial Configuration
- Web Configuration
- System Settings
- Management Settings
- Advanced Settings
- Wireless Settings
- Maintenance Settings
- Status Information
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client Commands
- 802.1X Authentication Commands
- MAC Address Authentication Commands
- Filtering Commands
- Spanning Tree Commands
- WDS Bridge Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- Wireless Security Commands
- Link Layer Discovery Commands
- VLAN Commands
- WMM Commands
- Appendices
- Troubleshooting
- Hardware Specifications
- Cables and Pinouts
- Glossary
- Index
C
HAPTER
9
| Maintenance Settings
Upgrading Firmware
– 105 –
the maximum length for file names is 32 characters for files on the
access point. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
◆ Remote — Downloads an operation code image file from a specified
remote FTP or TFTP server. After filling in the following fields, click Start
Upgrade to proceed.
■
New Firmware File: Specifies the name of the code file on the
server. The new firmware file name should not contain slashes (\ or
/), the leading letter of the file name should not be a period (.), and
the maximum length for file names on the FTP/TFTP server is 255
characters or 32 characters for files on the access point. (Valid
characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
■
IP Address: IP address or host name of FTP or TFTP server.
■
Username: The user ID used for login on an FTP server.
■
Password: The password used for login on an FTP server.
◆ Start Upgrade — Commences the upgrade process.