User's Manual
Table Of Contents
- Compliances
- About This Guide
- Contents
- Figures
- Tables
- Index of CLI Commands
- Getting Started
- Introduction
- Network Topologies
- Installing the access point
- Initial Configuration
- Web Configuration
- System Settings
- Management Settings
- Advanced Settings
- Wireless Settings
- Maintenance Settings
- Status Information
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client Commands
- 802.1X Authentication Commands
- MAC Address Authentication Commands
- Filtering Commands
- Spanning Tree Commands
- WDS Bridge Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- Wireless Security Commands
- Link Layer Discovery Commands
- VLAN Commands
- WMM Commands
- Appendices
- Troubleshooting
- Hardware Specifications
- Cables and Pinouts
- Glossary
- Index
– 170 –
19 RADIUS CLIENT COMMANDS
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access for RADIUS-aware devices to the network. An authentication
server contains a database of credentials, such as users names and
passwords, for each wireless client that requires access to the access point.
radius-server enable This command enables the RADIUS server.
SYNTAX
radius-server {primary | secondary} enable
primary - Specifies the primary RADIUS server.
secondary - Specifies the secondary RADIUS server.
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# radius-server primary enable
This setting has not been effective !
Table 17: RADIUS Client Commands
Command Function Mode Page
radius-server enable Enables the RADIUS server. GC 170
radius-server address Specifies the RADIUS server GC 171
radius-server port Sets the RADIUS server network port GC 171
radius-server key Sets the RADIUS encryption key GC 171
radius-server accounting
address
Sets the RADIUS server accounting address GC 172
radius-server accounting
port
Sets the RADIUS server accounting port GC 172
radius-server accounting
key
Sets the RADIUS server accounting key GC 173
radius-server accounting
timeout-interim
Sets the interval between transmitting
accounting updates to the RADIUS server
GC 173
show radius Shows the current RADIUS settings Exec 174