User's Manual
Table Of Contents
- Compliances
- About This Guide
- Contents
- Figures
- Tables
- Index of CLI Commands
- Getting Started
- Introduction
- Network Topologies
- Installing the access point
- Initial Configuration
- Web Configuration
- System Settings
- Management Settings
- Advanced Settings
- Wireless Settings
- Maintenance Settings
- Status Information
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client Commands
- 802.1X Authentication Commands
- MAC Address Authentication Commands
- Filtering Commands
- Spanning Tree Commands
- WDS Bridge Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- Wireless Security Commands
- Link Layer Discovery Commands
- VLAN Commands
- WMM Commands
- Appendices
- Troubleshooting
- Hardware Specifications
- Cables and Pinouts
- Glossary
- Index
C
HAPTER
4
| Initial Configuration
Quick Start
– 46 –
◆ Logout – Ends the web management session.
◆ Save Config – Saves the current configuration so that it is retained
after a restart.
QUICK START
The Quick Start menu is designed to help you configure the basic settings
required to get the access point up and running. Click ‘System’, followed by
‘Quick Start’.
STEP 1 The first page of the Quick Start configures the system identification,
access password, and the Country Code.
Figure 16: Quick Start - Step 1
The following items are displayed on the first page of the Quick Start
wizard:
IDENTIFICATION
◆ System Name — The name assigned to the access point.
(Default: 11n_AP)