User's Manual
Table Of Contents
- Compliances
- About This Guide
- Contents
- Figures
- Tables
- Index of CLI Commands
- Getting Started
- Introduction
- Network Topologies
- Installing the access point
- Initial Configuration
- Web Configuration
- System Settings
- Management Settings
- Advanced Settings
- Wireless Settings
- Maintenance Settings
- Status Information
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client Commands
- 802.1X Authentication Commands
- MAC Address Authentication Commands
- Filtering Commands
- Spanning Tree Commands
- WDS Bridge Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- Wireless Security Commands
- Link Layer Discovery Commands
- VLAN Commands
- WMM Commands
- Appendices
- Troubleshooting
- Hardware Specifications
- Cables and Pinouts
- Glossary
- Index
C
HAPTER
6
| Management Settings
Simple Network Management Protocol
– 69 –
Figure 30: SNMP Basic Settings
The following items are displayed on this page:
◆ SNMP — Enables or disables SNMP management access and also
enables the access point to send SNMP traps (notifications). (Default:
Disable)
◆ System Location — A text string that describes the system location.
(Maximum length: 255 characters)
◆ System Contact — A text string that describes the system contact.
(Maximum length: 255 characters)
◆ Read-Only Community — Defines the SNMP community access string
that has read-only access. Authorized management stations are only
able to retrieve MIB objects. (Maximum length: 23 characters, case
sensitive; Default: public)
◆ Read-Write Community — Defines the SNMP community access
string that has read/write access. Authorized management stations are
able to both retrieve and modify MIB objects. (Maximum length: 23
characters, case sensitive; Default: private)