User's Manual

QoS Configuration
105
5
Traffic Classification
This page is used to configure diffServ priorities based on protocol type, source and
destination addresses, and TCP/UDP port.
Click QoS, Traffic Classification. Select the classification method from the
drop-down list and fill in the required parameters, set the priority, click ADD to insert
the rule in the table, and then click Apply.
Figure 5-55 Traffic Classification
Field Attributes
• Method
- Protocol – Specifies the protocol type to match as TCP or UDP.
- Source Port – Source port number
1
(that is, protocol socket number) for the
specified protocol type.
- Source IP/Port – Source IP address, and port number
1
for the specified protocol
type.
- Destination Port – Destination port number
1
for the specified protocol type.
- Source IP/Port – Destination IP address, and port number
1
for the specified
protocol type.
- Protocol + Source IP/Port + Destination IP/Port – Source/destination IP
address, and port number
1
for the specified protocol type.
1. The TCP/UDP port range is 0-65535.