User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Network Planning
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Appendix A: Troubleshooting
- Appendix B: Cables
- Appendix C: Specifications
- Glossary
- Index
Initial Configuration
36
4
3. Click WIZARD when the home page appears.
Figure 4-2 Home Page
Using the Setup Wizard
There are only a few basic steps you need to set up the Gateway, and to configure
an IP address for the WAN interface (when operating in Router mode).
The Setup Wizard takes you through the configuration procedures shown below:
1. Select the Operating Mode – By default, the Gateway is set to operate in Bridge
mode, and requires no other features to be set before using the Advanced Setup
menu. If you plan on using the Gateway in Bridge mode, just click Next and skip
to Step 4. Otherwise, select Router mode, and click Next.
Figure 4-3 Mode Selection (Bridge Mode)