User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Network Planning
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Appendix A: Troubleshooting
- Appendix B: Cables
- Appendix C: Specifications
- Glossary
- Index
System Configuration
54
5
• Count Down – The time after which the connection will expire and the DHCP client
must request a new IP address.
• MAC Address – The MAC address of the DHCP client.
• IP Address – The IP address assigned to the DHCP client.
• Host – The host name of the DHCP client.
System Configuration
The System pages are used to configure basic administrative settings, including the
operating mode (bridge or router), NTP server selection, management access
control through a password or specified host address, firmware upgrade, UPnP
auto-discovery, and management through TFTP, Telnet or Secure Shell.
System Mode
This page sets the Gateway to operate as s bridge or router. Refer to “Networking
Concepts” on page 3-29 for a general description about these operating modes.
Click System, System Mode. Select the required operating mode, and click Apply.
Figure 5-9 System Mode - Bridge
Figure 5-10 System Mode - Router