CheetaHub Power-3008N/3016N Quick Installation Guide EH3008N(-SW) EH3016N(-SW) E1098-R01 150001-102
Copyright © 1998 by Accton Technology Corporation. All rights reserved. No part of this document may be copied or reproduced in any form or by any means without the prior written consent of Accton Technology Corporation. Quick Installation Guide Accton makes no warranties with respect to this documentation and disclaims any implied warranties of merchantability, quality, or fitness for any particular purpose. The information in this document is subject to change without notice.
CheetaHub Power-3008N/3016N Quick Installation Guide Contents Introduction Introduction 1 Package Contents 1 Description of Hardware 1 Mounting the Hub Stacking Hubs on a Flat Surface 2 2 Connecting the Hub System Making a Connection via an RJ-45 Station Port Making a Connection to the BNC Port (EH3016N, EH3016N-SW only) Making a Connection via an MDI Daisy-Chain Port Connecting to the Stacks Backplane 3 3 3 3 4 Powering On the Hub 4 Verifying Port Status 5 Verifying System Operation 5
CheetaHub Power-3008N/3016N Note: If more than one hub with internal switching is used in the stack, switching between stack segments will be managed by the unit highest in the stack, and internal switching will be disabled for all other units. These hubs provide a friendly design that simplifies installation and network troubleshooting.
CheetaHub Power-3008N/3016N Restrictions on Cascade Length - When cascading to another repeater, note that the attached repeaters will function as a single logical repeater, with all ports attached to the same collision domain. 10 Mbps Cascade - Based on the IEEE 802.3 recommendation, you may cascade up to four 10 Mbps hubs. 100 Mbps Cascade - When cascading to a Fast Ethernet hub, limit the daisychain to two hubs. Another limitation for cascading Fast Ethernet concerns connection length.
CheetaHub Power-3008N/3016N Quick Installation Guide Cascading Hubs with the Daisy-Chain Port - You can easily connect to another hub or switch via the RJ-45 MDI daisy-chain port on the front panel. The figure below shows a sample configuration. When connecting to 10 Mbps Ethernet, the maximum number of hubs that can be cascaded is four (with up to 100 meters or 328 feet of cable allowed between each hub).
CheetaHub Power-3008N/3016N Quick Installation Guide Installation Verify that all system components have been properly installed. If one or more components appear to be malfunctioning (e.g., the power cord or network cabling), test them in an alternate environment where you are sure that all the other components are functioning properly. Port and Cable Assignments RJ-45 Port Description RJ-45 (MDI-X) station ports can be attached to any devices which use a standard network interface (e.g.
CheetaHub Power-3008N/3016N Quick Installation Guide EMI Certification (EH3016N) Safety Compliance FCC Class A Certification (USA) Underwriters Laboratories Inc. (USA) Warning: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications.
CheetaHub Power-3008N/3016N Quick Installation Guide Warranty Accton warrants to the original owner that the product delivered in this package will be free from defects in material and workmanship for a period of three years from the date of purchase from Accton or its Authorized reseller. For the warranty to apply, you must register your purchase by returning the registration card indicating the date of purchase and including proof of purchase.