System information

System Defaults
1-5
1
System Defaults
To reset the switch defaults:
1. Remove the power cord from the back of the switch.
2. Remove all cables from the front-panel ports.
3. Use a standard network cable to connect port 1 to port 2 on the front panel.
4. Reconnect the power cord to the switch.
5. Wait at least 40 seconds before disconnecting port 1 from port 2.
The following table lists some of the basic system defaults.
Table 1-2 System Defaults
Function Parameter Default
Authentication Web Management Password “admin“
802.1X Port Authentication Disabled
Port Security Disabled
IP Filtering Disabled
SNMP SNMP Agent Enabled
Community Strings “public” (read only)
“private” (read/write)
Traps Enabled
Port Configuration Admin Status Enabled
Auto-negotiation Enabled
Flow Control Disabled
Rate Limiting Input and output limits Disabled
Port Trunking Static Trunks None
Broadcast Storm
Protection
Status Disabled (all ports)
Broadcast Limit Rate 1K frames per second
Spanning Tree
Protocol
Status Disabled (all ports)
(Defaults: All values based on IEEE 802.1w)
Fast Forwarding (Edge Port) Enabled
Virtual LANs Default VLAN 1
PVID 1
Acceptable Frame Type All