User's Manual
Table Of Contents
- Compliances
- Chapter 1 About This Guide
- Chapter 2 About the IronPoint 250
- Chapter 3 Network Planning
- Chapter 4 Installing the IronPoint 250 Access Point
- Chapter 5 Making a Network Connection
- Appendix A Troubleshooting
- Appendix B Cables
- Appendix C Specifications
- Glossary
- Index
Foundry IronPoint 250 Installation Guide
4-4 © 2007 Foundry Networks, Inc. July 2007
Figure 4-3. Attaching the Ceiling-Mount Clamp to the Mounting Bracket
2. Attach the access point to the mounting bracket by aligning the two mounting points on the
bracket with the two mounting slots on the bottom of the access point (Figure 4-2). Then screw
down the fastening screw to secure the access point to the bracket.
3. Choose a location on a ceiling T-rail where the access point will be installed and position the
ceiling-mount clamp holders on either side of the T-rail.
4. Turn the access point until the two clips lock the T-rail into the mounting holders.
5. For best coverage, position the antennas along the same axes.
Mounting Holders
Fastening Screws
Mounting Clip