User's Manual
Table Of Contents
- Compliances
- Chapter 1 About This Guide
- Chapter 2 About the IronPoint 250
- Chapter 3 Network Planning
- Chapter 4 Installing the IronPoint 250 Access Point
- Chapter 5 Making a Network Connection
- Appendix A Troubleshooting
- Appendix B Cables
- Appendix C Specifications
- Glossary
- Index
Foundry IronPoint 250 Installation Guide
4-10 © 2007 Foundry Networks, Inc. July 2007
8. Connect one end of the Ethernet cable to the RJ-45 connector on the access point.
9. Connect the other end of the cable to the network subnet for which the access point was
programmed.
10. Power up the access point. It can now be managed using its command line interface (CLI), Web
interface, or by the IronView Network Manager.
Once the access point is set up with country code and IP address, other parameters can be defined
using one of the following methods:
• A PC running Internet Explorer version 5.0 (and above) Web browser to directly access an
individual Foundry AP’s internal Web management interface.
• A PC running IronView® Network Manager to centrally manage the APs on the network.
• A Telnet or SSH v2 client to directly access Foundry AP’s command line interface (CLI).
Refer to the Foundry IronPoint 250 User Guide for details.