User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Network Configuration
- Chapter 3 Hardware Installation
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- radio-mode
- select-antenna-mode
- description
- ssid-broadcast
- closed-system
- speed
- channel
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Specifications
- Appendix C Cables and Pinouts
- Glossary
- Index
System Configuration
5-58
• MAC Address: The physical layer address for this device.
• System Name: Name assigned to this system.
• System Contact: Administrator responsible for the system.
• IP Address: IP address of the management interface for this
device.
• IP Default Gateway: IP address of the gateway router between
this device and management stations that exist on other
network segments.
• HTTP Server: Shows if management access via HTTP is
enabled.
• HTTP Server Port: Shows the TCP port used by the HTTP
interface.
• Version: Shows the version number for the runtime code.
AP Wireless Configuration – The AP Wireless Configuration table
displays the wireless interface settings listed below. The 802.11b/
g interface.
• SSID: The service set identifier for this wireless group.
• Radio Channel: The radio channel through which the access
point communicates with wireless clients.
• Radio Encryption: The key size used for data encryption.
• Radio Authentication Type: Shows if open system or shared
key authentication is used.
• 802.1x: Shows if IEEE 802.1x access control for wireless
clients is enabled.
CLI Commands for Displaying System Settings – To view the
current access point system settings, use the show system
command from the Exec mode. To view the current radio interface