User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Network Configuration
- Chapter 3 Hardware Installation
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- radio-mode
- select-antenna-mode
- description
- ssid-broadcast
- closed-system
- speed
- channel
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Specifications
- Appendix C Cables and Pinouts
- Glossary
- Index
Advanced Configuration
5-29
Before upgrading new software, verify that the SMC2552W-G is
connected to the network and has been configured with a
compatible IP address and subnet mask.
If you need to download from an FTP or TFTP server, take the
following additional steps:
• Obtain the IP address of the FTP or TFTP server where the
access point software is stored.
• If upgrading from an FTP server, be sure that you have an
account configured on the server with a user name and
password.
• If VLANs are configured on the access point, determine the
VLAN ID with which the FTP or TFTP server is associated,
and then configure the management station with the same
VLAN ID. If you are managing the access point from a wireless
client, the VLAN ID for the the wireless client must be
configured on a RADIUS server.
Current version – Version number of runtime code.