User's Manual

System Configuration
5-34
number to use on the Syslog server. To view the current logging
settings, use the show logging command.
Configuring SNTP
Simple Network Time Protocol (SNTP) allows the SMC2552W-G
to set its internal clock based on periodic updates from a time
server (SNTP or NTP). Maintaining an accurate time on the
access point enables the system log to record meaningful dates
and times for event entries. If the clock is not set, the access point
will only record the time from the factory default set at the last
bootup.
The SMC2552W-G acts as an SNTP client, periodically sending
time synchronization requests to specific time servers. You can
configure up to two time server IP addresses. The access point
will attempt to poll each server in the configured sequence.
SMC-AP(config)#logging on 6-24
SMC-AP(config)#logging level alert 6-26
SMC-AP(config)#logging console 6-25
SMC-AP(config)#logging host 1 10.1.0.3 514 6-24
SMC-AP(config)#logging facility-type 19 6-27
SMC-AP(config)#exit
SMC-AP#show logging 6-27
Logging Information
============================================
Syslog State : Enabled
Logging Host State : Enabled
Logging Console State : Enabled
Server Domain name/IP : 1 10.1.0.3
Logging Level : Error
Logging Facility Type : 16
=============================================
SMC-AP#