User Manual

SMCWUSB-N2 802.11n Wireless USB 2.0 Adapter
4
Chapter 2. Installation Guide
2.1 Hardware Installation
There are two options for installing the SMC Adapter:
Option 1: Plug the Adapter directly into the USB port on your computer.
Option 2: Connect the Adapter and your computer through the USB extension cable in the
package.
The LED will light up when the Adapter is installed successfully and the PC is switched on.
2.2 Software Installation
2.2.1 Overview
The SMCWUSB-N2 EZ Installation Wizard will guide you through the Installation procedure for
Windows XP. The Setup Wizard will install the SMCWUSB-N2 Wireless Utility and drivers.
When you install the hardware prior to before installing the software, the system will prompt
“Found New Hardware Wizard”, click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 2000 and XP are similar. The next section of this manual uses
Windows XP as an example.
For the Setup steps in Windows Vista, please follow the onscreen instructions.
2.2.2 Software Installation for Windows XP
1. Insert the EZ Installation & Documentation CD into your CD-ROM drive. The CD will auto
run. Click Install/Remove Driver and Utility and follow the on-screen instructions.
)
Note:
If a “Software Installation” warning appears during installation, click Continue Anyway.