User Manual

SMCWUSB-N2 802.11n Wireless USB 2.0 Adapter
26
Chapter 5. WPS configuration
The Wi-Fi Protected Setup (WPS) function allows you to establish a wireless connection with
your WPS-enabled wireless router or access point easily, using either Push Button
Configuration (PBC) method or PIN method.
Install the WPS software on your computer. Insert the EZ Installation & Documentation CD into
your CD-ROM drive. The CD will auto run. Click Install/Remove WPS (WiFi Protected Setup).
Figure 5-1
Follow the on-screen instructions to complete the WPS installation. After that, the WPS function
can be enabled. The following section introduces two ways to configure WPS.
5.1 PBC (Push Button Configuration) method
1. On the management interface of your wireless router/AP, make sure WPS is enabled.
Press the WPS button on your WPS-enabled wireless router or access point for 4 seconds.
Within two minutes, press the WPS button on the SMCWUSB-N2 adapter to join the
wireless network.
2. Double click the WPS icon
on the desktop to start the WPS Utility. Click Next to
continue.