User's Manual

4/3/03 Accton Draft—CONFIDENTIAL

14 Aruba 50 Part 0500007A

Installation Guide May 2003

Mount the Aruba 50

When initial setup is complete, mount the Aruba 50 in its intended service location.

Select a location as close as possible to the center of the intended coverage area. If necessary,

use the Aruba WLAN Switch’s built-in site survey software to determine the optimum loca-

tions for your access points and air monitors (see your Aruba AirOS Software Guide).

The service location should be free from obstructions or obvious sources of interference. Nor-

mally, the higher you place an access point or air monitor, the better its performance.

The Aruba 50 can be mounted in the following ways:

FIGURE 2-2 Aruba 50 Mounting Options

Flat on a table or shelf (with the LEDs on top) either free-standing or using the

included mounting kit

Upright on a wall (with the port connectors on top) using the included mounting kit

Suspended from above (with the LEDs on bottom) using the included mounting kit

CAUTION—For safety purposes, do not mount the Aruba 50 sideways (with the air

vents on top and bottom).