User Manual
Table Of Contents
009-10602-A Legra Radio Installation Guide
Mounting Instructions 21
Legra Systems Inc. Proprietary and Confidential
To imprint LS2012 information on a Legra Radio
1 Connect a category 5 Ethernet cable to the Legra Switch 10/100
Ethernet port.
2 Connect the cable to the Legra Radio’s RJ-45 Ethernet Port.
The green Legra Radio Power LED blinks slowly. The LED turns
solid green when imprinting is complete.
The Legra Radio is imprinted.
Connecting Power to the Legra Radio
Use one of the following methods to provide power to the Legra Radio:
• Power over Ethernet (PoE)
• Inline Power Injector
• Power Brick
Power over Ethernet (PoE)
If you connect a Legra Radio directly to a Legra Switch, the Legra
Radio operates on PoE from the Legra Switch. After you connect a
category 5 Ethernet cable to your Legra Switch, additional power
connections are not required.
You can also connect your Legra Radio to a third party switch. If the
third party switch does not support PoE, use an inline power injector or
power brick to power the Legra Radio. If the third party switch supplies
Power over Ethernet, additional power connections are not required.