User Manual

Introduction
1-4
1
LED Indicators
The wireless AP/Router includes nine status LED indicators, as described in the
following figure and table.
Figure 1-4. LED Indicators
*
Slow flashing is an on-off cycle of once every 2 seconds. The flashing lasts for 10
seconds then stops.
LED Status Description
POWER On Green Indicates that the system is working normally.
WAN On/Flashing Green Indicates a valid link on the WAN Ethernet port. Flashing indicates
network activity.
Off The Ethernet port has no valid link.
LAN (4 LEDs) On/Flashing Green Indicates a valid link on the LAN Ethernet port. Flashing indicates
network activity.
Off The Ethernet port has no valid link.
WLAN On/Flashing Green Indicates the 802.11n radio is enabled. Flashing indicates wireless
network activity.
Off Indicates the 802.11n radio is disabled.
WPS On (for 10 seconds) Indicates the WPS authentication of a device has been successfully
completed.
Fast Flashing Green Indicates the WPS authentication of a client device is in progress.
Slow Flashing Green
(for 10 seconds)*
Indicates the WPS authentication of a device did not complete after 120
seconds.
Off Indicates that WPS is not in progress.
3G Link On Indicates a connection through the attached 3G/3.5G USB modem.
Fast Flashing Green Indicates that the PIN code has failed.
Slow Flashing Green Indicates that the 3G/3.5G USB modem is in the process of connecting.
Off Indicates that there is no connection or no attached 3G/3.5G device.
Power
WPS Link/Activity
802.11n Link/Activity
WAN Link/Activity
LAN Link/Activity
3G Link