User Manual

System Configuration
5-4
5
Network Settings
The Network Settings pages allow you to manage basic system configuration
settings.
Note: In AP mode, the wireless AP/Router’s Network Settings options are significantly
reduced.
Management IP
Assigns an IP address for connecting to the wireless AP/Router. Click on "Network
Settings" followed by "Management IP.”
Figure 5-3. IP Settings (AP mode)
• Management IP Address – Specifies an IP address for management of the
wireless AP/Router. Valid IP addresses consist of four decimal numbers, 0 to 255,
separated by periods. (Default: 192.168.1.254.)
PING Test Performs a loopback test on a specified IP address Both 5-59
Management 5-60
Admin Enables remote administration and configures user accounts
for control of the unit
Both 5-60
Config Backups and restores the configuration data and restores the
factory defaults
Both 5-62
Firmware Upgrades system software from a local file and enables
provisioning updates
Both 5-63
Information 5-64
System Information Displays the current system status Both 5-64
Routing Table Displays information on configured routes Router 5-67
Packet Statistics Displays received and sent packet statistics Both 5-67
System Log Displays the system message log Both 5-69
Table 5-1. Configuration Options
Menu Description Mode Page