User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Quick Setup
- Chapter 4: Configuration
- Appendix A: Troubleshooting
- Appendix B: Specifications
- Appendix C: Configuration File
- Appendix D: Using Partial Scan
- Appendix E: Registry Settings
The Config Screen
4-3
The Config Screen
From the WinemaCM main screen, click the CONFIG button to open the Config
screen. The settings available from this screen control various features of the
software. These settings are described below:
• Connection Scheme — Sets the software to automatically connect to a WiMAX
service or to connect only when the user clicks the Connect button.
Note: The Connection Mode set in a profile has a higher priority and overrides the
Connection Scheme setting on this screen.
• Notification — Enables notifications to tell the user when the receive signal is poor
and if the user moves outside the WiMAX coverage zone.
• Startup Program — Sets the WinemaCM software to start when Windows XP or
WIndows Vista starts.
• Roaming — Roaming is not supported by the current software.
• Skin — Selects the display type for the WinemaCM software.
Note: Be sure to always click the SAVE button to apply your changes.
Be sure to click the SAVE
button to retain any
configuration changes.