User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Quick Setup
- Chapter 4: Configuration
- Appendix A: Troubleshooting
- Appendix B: Specifications
- Appendix C: Configuration File
- Appendix D: Using Partial Scan
- Appendix E: Registry Settings
D-1
Appendix D: Using Partial Scan
The section shows how to set up the WiMAX PCMCIA Card to use partial scan.
Follow these steps:
1. Change the following parameters in the Configuration file:
Center Frequency = 0
PhyParameter2 = 0x1
See Appendix C for details on the Configuration file.
2. Find the registry entry “HKEY_LOCAL_MACHINE\SOFTWARE\Intel
Corporation\WiMAX” and set the PartialScan value to 1. (The value 0 means do
not use partial scan.)
3. Add the Bandwidths you want to scan to the following registry entries:
HKEY_LOCAL_MACHINE\SOFTWARE\Winema\ParticalScan\BWS1
HKEY_LOCAL_MACHINE\SOFTWARE\Winema\ParticalScan\BWS2
HKEY_LOCAL_MACHINE\SOFTWARE\Winema\ParticalScan\BWS3
Set value to 1 to use partial
scan.
Select PartialScan and press
Enter to edit the value.