Quick Installation Guide

Wireless PC Card
10
Utility Configuration
Using Monitor Utility
The configuration utility was installed at the same time the driver was installed.
Double-click the icon at the bottom-right corner of the desktop to launch the utility. Or you
can access from the Start menu, as shown below.
Status
When you start the Wireless LAN Card utility, the information window for the Wireless
LAN Card is shown as in the figure below. By clicking the Rescan button, the wireless
card will be forced to rescan the network signal spectrum and connect to an access point
with the best available signal quality. If you want to disable the radio, click Disable Radio.
(Radio Default: Enable)
State — Shows the MAC address of the associated access point (BSSID).
Current Tx Rate — Indicates the data transmission rate.
wn3306-ZZ.book Page 10 Friday, April 18, 2003 3:55 PM