User's Manual
3 WINDOWS 2000/XP CONFIGURATION
ACCESSING THE Zero-config
Once the driver installation is complete, You can use Windows Zero-config to link on
WiFi AP.
A TROUBLESHOOTING
USB ADAPTER INSTALLATION PROBLEMS
If your computer cannot find the WUS622C-A Wireless USB Adapter or the
network driver does not install correctly, check the following items:
◆Make sure the adapter is connected to the USB port. Check for any
hardware problems, such as physical damage to the adapter’s
connector.
◆Try the adapter in another USB port. If this also fails, try using another
WUS622C-A wireless adapter that is known to operate correctly.
◆Check for a defective computer or USB port by trying the adapter in
another computer that is known to operate correctly.
NETWORK CONNECTION PROBLEMS
If the Link/Activity LED on the USB adapter is not lit, or if you cannot
access network resources from the computer, check the following:
◆Make sure the correct software driver is installed. Try reinstalling the
driver.
◆Make sure the computer and other network devices are receiving
power.
◆The access point you want to connect to may not be functioning
correctly. Try using another access point.
◆If you cannot access a Windows service on the network, check that you
have enabled and configured the service correctly. If you cannot
connect to a particular server, be sure that you have access rights and
a valid ID and password.
◆If you cannot access the Internet, be sure you have currently
configured your system for TCP/IP.
If your wireless station cannot communicate with a computer on the
Ethernet LAN when configured for Infrastructure mode, check the
following:
A
PPENDIX A | Troubleshooting