User Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installing the OD200
- Chapter 3: Initial Configuration
- Chapter 4: System Settings
- Chapter 5: Gateway Configuration
- Chapter 6: WiMAX Settings
- Chapter 7: VoIP Settings
- Chapter 8: Wi-Fi Settings
- Appendix A: Troubleshooting
- Appendix B: Specifications
- Appendix C: Cables and Pinouts
- Appendix D: License Information
- Glossary
- Index
WAN Settings
5-5
5
PPPoE Settings
If your service provider supports Point-to-Point Protocol over Ethernet (PPPoE) for
your Internet connection, configure the settings described below.
Figure 5-5 PPPoE Settings
PPPoE Network Server – The IP address of the PPPoE server, as specified by the
service provider.
Keep Alive – This option enables the unit to check periodically that the PPPoE
connection is still operating. If the connection is found to be lost, the unit
automatically attempts to reconnect to the service provider. (Default: Enabled)
Keep Alive Time – The time period the unit waits before checking that the PPPoE
connection is still operating. This parameter only applies when Keep Alive is
enabled. (Default: 60 seconds; Range: 10-180 seconds)