User Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installing the OD200
- Chapter 3: Initial Configuration
- Chapter 4: System Settings
- Chapter 5: Gateway Configuration
- Chapter 6: WiMAX Settings
- Chapter 7: VoIP Settings
- Chapter 8: Wi-Fi Settings
- Appendix A: Troubleshooting
- Appendix B: Specifications
- Appendix C: Cables and Pinouts
- Appendix D: License Information
- Glossary
- Index
Wi-Fi Settings
8-8
8
format (length is 64). All wireless clients must be configured with the same key to
communicate with the VAP interface.
The WPA-WPA2-Mixed-PSK mode is a transitional mode of operation for networks
moving from WPA security to WPA2. WPA-WPA2-Mixed-PSK mode allows both
WPA and WPA2 clients to associate to a common Wi-Fi interface.
Figure 8-5. WPA/WPA2 PSK Security
WPA Pre-Shared Key – The key required for WPA-PSK, WPA2-PSK, and
WPA-WPA2-Mixed-PSK modes. There are.two methods for key entry: An ASCII
string of 8~63 characters in length (0~9, A~F, including spaces), or 64 hexadecimal
digits.
MAC Authentication
Wireless clients can be authenticated for network access by checking their MAC
address against a local database configured on the OD200. You can configure a list
of up to 32 wireless client MAC addresses in the filter list to either allow or deny
network access.