User Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installing the OD200
- Chapter 3: Initial Configuration
- Chapter 4: System Settings
- Chapter 5: Gateway Configuration
- Chapter 6: WiMAX Settings
- Chapter 7: VoIP Settings
- Chapter 8: Wi-Fi Settings
- Appendix A: Troubleshooting
- Appendix B: Specifications
- Appendix C: Cables and Pinouts
- Appendix D: License Information
- Glossary
- Index
Cables and Pinouts
C-2
C
Straight-Through Wiring
If the twisted-pair cable is to join two ports and only one of the ports has an internal
crossover (MDI-X), the two pairs of wires must be straight-through.
Figure C-2 Straight-Through Wiring
Crossover Wiring
If the twisted-pair cable is to join two ports and either both ports are labeled with an
“X” (MDI-X) or neither port is labeled with an “X” (MDI), a crossover must be
implemented in the wiring.
Table C-1. 10/100BASE-TX MDI and MDI-X Port Pinouts
Pin MDI-X Signal Name MDI Signal Name
1 Receive Data plus (RD+) Transmit Data plus (TD+)
2 Receive Data minus (RD-) Transmit Data minus (TD-)
3 Transmit Data plus (TD+) Receive Data plus (RD+)
4 Positive V
port
Positive V
port
5 Positive V
port
Positive V
port
6 Transmit Data minus (TD-) Receive Data minus (RD-)
7 Negative V
port
Negative V
port
8 Negative V
port
Negative V
port
Note: The “+” and “-” signs represent the polarity of the wires that make
up each wire pair.
White/Orange Stripe
Orange
White/Green Stripe
Green
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
EIA
/
TIA 568B RJ-45 Wiring
S
tandard
10/100BASE-TX Straight-through Cable
End A
End B
Blue
White/Blue Stripe
Brown
White/Brown Stripe