Technical data

85
Testing blood glucose
5
i
Once the flashing blood drop symbol has appeared, you have
approx. 90 seconds to apply blood to the test strip. After this
time, the meter automatically turns off. Remove the test strip by
pushing the ejector down (see page 86) and discard the test
strip. Start the blood glucose test again with a new test strip.
i
If the test does not start, the test strip drew up too little blood. In
this case you can allow the test strip, within a certain period, to
draw up more blood (see the package insert that came with the
test strips).
i
If the meter beeps not once but several times when displaying
the result, either the target range is turned on and the result is
below the lower limit or above the upper limit (see Chapter
3.2.6), or Acoustic Mode is turned on (see Chapters 3.2.5 and 7).