Owner Manual

DETAILED TEMPERATURE CONTROLLER

GUIDE

Front Panel Operation

1. Set temperature (compressor’s top temperature) adjustment:

Press the SET button, the set temperature is displayed, then press the UP or DOWN arrow to

store and memorize. Press the SET button to exit the adjustment status and display the product

temperature. If no more buttons are pressed within 6 seconds, the refrigerator prod uct

temperature will be displayed.

(Set temperature adjustment range: Parameter E1～E2)

2. Manually start/stop defrosting:

Press HI/LO button, then press SET button and hold for 6 seconds to enter defrost status or to stop

defrost.

3. Display the sensor temperature (C13):

Press the DOWN arrow, the product temperature (or cabinet temperature) will flash display. After 6

seconds, will resume normal display.

4. Refrigeration LED:

During refrigeration the cooling snowflake LED is on. When temperature is constant, the LED is off.

5. Defrost LED:

During defrosting (if activated), the defrost LED is on. During the delay after defrosting, the LED

flashes.

6. Parameter set-up and settings (for all settings other than temperature setpoint):

Press SET button and hold for 6 seconds to enter the parameter setting (flash and display PAS). After

entering the correct password (factory default is 15), press SET and the display will show E1, E2,

…~do3 PAS in sequence. Press the UP or DOWN arrow and the value of the parameter will be

displayed and can be modified and stored. If no other buttons are pressed within 6 seconds, it will exit,

and the new value will be stored. NOTE: Only when in the inner parameter menu (display PAS) and the

correct password is entered can the parameter value be adjusted. If the wrong password is entered, the

parameter modification will be exited, although the set temperature adjustment is still active. If you

forget the password, you will need to resume the factory default settings.

The following are examples of how to change common settings:

A) Enter Password - Press and hold the “Set” button 6 seconds until it flashes “Pas”, then

enter the default password “15” using the up and down arrows. When “15” is reached press the

“Set” button.