Manualshelf

User Manual

ManualsBrandsAccuCold ManualsFreezers20 Inch Built-In All-Freezer with 2.8 Cu. Ft. Capacity, NIST Calibrated Thermometer, Digital Thermostat, Buffered Temperature Probe, Temperature Alarm, Lock, and ETL & ETL-C Listed
12345678910
4
Installation Instructions
Excessive Weight Hazard !
Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury.
ALLOW APPLIANCE TO SIT
UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO
ALLOW THE COMPRESSOR LUBRICANT TO DRAIN.
1.
Remove packaging materials.
2.
Remove tape and glue residue from surfaces before turning on the appliance. Rub a
small amount of liquid dish soap over the adhesive with your f
ingers. Rinse with warm
water and dry.
3.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your appliance.
4.
When Moving Your Appliance:
Your appliance is hea
vy. When moving the appliance for cleaning or service, be sure to
protect the floor. Always pull the appliance straight out when moving it. Do not wiggle or
“walk” the appliance when trying to move it, because floor damage can occur.
5.
Clean Before Using:
Af
ter you remove all of the packaging materials, clean the inside of your appliance
before using it. See cleaning instructions in Appliance Care.
6.
Some upright models have leveling legs. Level as necessary for best
operation.
7.
If your appliance has casters, after moving into place, lock the brakes on those casters
supplied with brakes. Always unlock before moving the appliance for cleaning.
Key Eject lock (some models):
To lock or unlock the appliance, you must hold the key in
the lock while turning. The lock is
spring loaded, so the key cannot be left in the lock.
If the key is lost, contact your dealer or SUMMIT APPLIANCE for a replacement. Always
give the model and serial number of your appliance when requesting a replacement
Keys for most models can be ordered online at
www.summitappliance.com/support
A NOTE ABOUT DOOR SWING:
Due to their wiring and controls, the doors on all MED2 units
cannot be reversed in the
field.
When ordering in the future, always specify whether you need a right hand or left
hand (option “LHD”) door swing. All units ship with a right hand door swing unless specified
differently at the time of order.
Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury.
UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO
Remove tape and glue residue from surfaces before turning on the appliance. Rub a
ingers. Rinse with warm
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your appliance.
vy. When moving the appliance for cleaning or service, be sure to
protect the floor. Always pull the appliance straight out when moving it. Do not wiggle or
“walk” the appliance when trying to move it, because floor damage can occur.
ter you remove all of the packaging materials, clean the inside of your appliance
If your appliance has casters, after moving into place, lock the brakes on those casters
supplied with brakes. Always unlock before moving the appliance for cleaning.
the lock while turning. The lock is
If the key is lost, contact your dealer or SUMMIT APPLIANCE for a replacement. Always
give the model and serial number of your appliance when requesting a replacement
key.
www.summitappliance.com/support
cannot be reversed in the
When ordering in the future, always specify whether you need a right hand or left
hand (option “LHD”) door swing. All units ship with a right hand door swing unless specified