BLANKET WARMER MODELS: PTHC65G Series PTHC125G Series PTHC155G Series User Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write model and serial numbers here/ Écrivez les numéros de modèle et de série ici: _______________________________________ FELIX STORCH, INC.
TABLE OF CONTENTS Important Safeguards 3 Installation 4-5 Before Using the Warming Cabinet 4 Installing your Appliance 4 Reversing the Door Swing 5 Installing the Door Handle 5 Operation 6 Loading the Warming Cabinet 6 Turning on the Warming Cabinet 6 Turning off the Warming Cabinet 6 Reducing the Set Point Temperature 6 Cleaning and Maintenance 7 Cleaning 7 Extended Downtime 7 Moving your Appliance 7 Energy Saving Tips 7 Preventive Maintenance 7 Troubleshooting 8 Wiring
IMPORTANT SAFEGUARDS Your safety and the safety of others are very important to us. We have provided several important safety messages in this manual. Read all safety messages and always obey them when operating this appliance. Serious injury or even death may result if you do not follow these instructions.
INSTALLATION Before Using the Warming Cabinet • • • • • Remove the exterior and interior packaging. Check to be sure the shelves are installed and that the strips of tape holding them in place have been removed. Level the appliance with the adjustable legs provided. The circuit breaker on the control panel should be in the OFF position. Clean the interior surfaces with lukewarm water using a soft cloth.
Reversing the Door Swing (Only applicable to the PTH65G Series) The door of the warming cabinet can be hinged on either side so that the door swing can be suited to the location of the installation. In order to reverse the position of the door hinges, refer to the disassembly diagrams below this procedure. 1. Lay the warming cabinet onto its back side, being careful to set it onto a blanket or another soft surface. 2. Remove the screws holding the bottom hinge, and remove the hinge. 3.
OPERATION NOTE: This appliance is designed to heat towels and blankets to temperatures of up to 140°F. The process of heating the contents from an ambient room temperature of 72°F up to 140°F can take an average of 4 hours, depending on the amount of contents. When loading items into the cabinet for heating, be sure there is a minimum of 1” of space between the items and the walls to allow for proper circulation of air.
CLEANING AND MAINTENANCE Cleaning • • • • • Unplug the appliance and remove all contents. Wash the interior liner with a solution of warm water and baking soda (two tablespoons per quart). Then rinse and wipe. Do not use soaps, detergents, scouring powder, spray cleaners or the like on the liner, as these may cause odors in the cabinet. Wash shelves in a mild detergent solution and dry with a soft cloth. Wipe the exterior surface with a soft cloth dampened with soapy water and then dry with a soft cloth.
TROUBLESHOOTING You can easily solve many common problems with your appliance, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling a service technician. TROUBLESHOOTING GUIDE Problem Appliance does not get warm. Appliance turns on but does not reach the set temperature. The door will not close properly. Possible Cause Not plugged in; power is off. The circuit breaker has tripped or fuse has blown. Door is not closed.
WIRING DIAGRAM 9
LIMITED WARRANTY ONE YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
TABLE DES MATIERES Mesures de sécurité importantes 12 Installation 13-15 Avant d'utiliser l'armoire chauffante 13 Installation de votre appareil 13 Inversion de la porte battante 14 Installation du poignée de la porte 15 Fonctionnement 15-16 Chargement de l’armoire chauffante 15 Mise sous tension de l’armoire chauffante 15 Mise hors tension de l'armoire chauffante 15 Réduire la température du point de consigne 16 Nettoyage et entretien 16 Nettoyage 16 Temps d'arrêt prolongé 16 Dé
MESURES DE SECURITE IMPORTANTES Votre sécurité et celle des autres est très importante pour nous. Nous avons fourni plusieurs messages de sécurité importants dans ce manuel. Lisez tous les messages de sécurité et respectez-les toujours lorsque vous utilisez cet appareil. Des blessures graves ou même la mort peuvent survenir si vous ne suivez pas ces instructions.
INSTALLATION Avant d'utiliser l'armoire chauffante • • • • • Retirez l’emballage extérieur et intérieur. Assurez-vous que les étagères sont installées et que les bandes de papier collant qui les maintiennent en place ont été enlevées. Nivelez l'appareil avec les pieds réglables fournis. Le disjoncteur sur le panneau de commande doit être en position OFF. Nettoyez les surfaces intérieures avec de l'eau tiède à l'aide d'un chiffon doux.
Inversion de la porte battante (Uniquement applicable à la série PTH65G) La porte de l'armoire chauffante peut être articulée de chaque côté de telle sorte que l'ouverture de la porte peut être adaptée à la situation de l'installation. Afin d'inverser la position des gonds de la porte, référez-vous aux schémas de démontage ci-dessous et suivez cette procédure. 1. Posez l'armoire chauffante sur sa face arrière, en prenant soin de la placer sur une couverture ou une autre surface douce. 2.
FONCTIONNEMENT REMARQUE: Cet appareil est conçu pour chauffer les serviettes et couvertures à une température ne dépassant pas 140°F. Le processus de chauffage du contenu à partir d'une température ambiante de 72°F jusqu’à140°F peut prendre de 25 minutes à 3 heures de temps, en fonction de la quantité du contenu.
Réduire la température du point de consigne La température de fonctionnement est à réglage d’usine de 120°F, mais vous pouvez réduire ce ‘’Set Point’’ (point de consigne) en suivant cette procédure: 1. Appuyez et relâchez le bouton SET. La température d'affichage clignote. 2. Appuyez sur la flèche HAUT ou BAS du panneau de commande pour atteindre la température souhaitée (point de consigne). REMARQUE: La plage de température de cet appareil réglée en usine est de 90°F à 140°F.
DÉPANNAGE Vous pouvez facilement résoudre nombreux problèmes communs avec votre appareil, vous épargnant le coût d'un appel de service possible. Essayez les suggestions ci-dessous pour voir si vous pouvez résoudre le problème avant d'appeler un technicien de service. GUIDE DE DÉPANNAGE Problèmes L'appareil ne chauffe pas. Appareil est allumé, mais n'atteint pas la température de consigne. La porte ne se ferme pas correctement. Causes possibles Pas branché; l'alimentation est coupée.
SCHEMA DE CABLAGE 18
REMARQUES 19
GARANTIE LIMITÉE UN AN DE GARANTIE LIMITEE Dans les 48 États américains contigus, pendant un an à partir de la date d'achat, lorsque cet appareil est utilisé et entretenu conformément aux instructions jointes à, ou fournies avec le produit. Le garant paiera pour les pièces spécifiées en usine et pour la main-d’œuvre pour corriger les vices de matériaux ou de fabrication. Le service doit être fourni par une compagnie de service désignée.