User Manual

• In all small refrigerators and freezers without interior fans, temperatures are coldest near the

bottom, and occasionally near the rear. Place contents accordingly.

NOTE: For optimum temperature performance, it is recommended that your unit be at least 30% full

during use. If you are only using this unit to store small loads, we recommend adding some

water bottles or freezer packs to ensure temperature stability.

Digital Thermostats (standard on all refrigerators, ACF48W models, and

VT65MLADA models)

If you find it necessary to change the temperature setting for your digital thermostat, please refer to

the following instructions.

NOTE: The minimum and maximum range of your thermostat is preset and locked so it cannot

easily be accidentally moved outside of the recommended temperature ranges.

To See the Set Point:

The default display for your digital thermostat is the internal cabinet temperature. To view the unit’s

set point, push and immediately release the SET key. The display will flash, showing the set point

value. If no other actions are taken in 6 seconds, the display will revert to the internal air

temperature.

To Change the Set Point:

While the set point value is blinking, press the UP or DOWN arrow to change the set point to your

desired temperature. Press the SET button again to exit the adjustment. The display will revert to the

internal air temperature.

NOTE: The temperature displayed on the digital thermostat is the internal air temperature. Your

alarm/thermometer (installed on the left in the control panel) provides a temperature readout

based on the buffered probe in order to better simulate the temperature of what is actually

stored inside the unit (as opposed to the air temperature itself). As a result, these readings

may not always display the same temperature reading.

Thermometer (PLUS2 Models)

• This digital thermometer simultaneously displays maximum, minimum

and current temperatures. The Max/Min feature monitors and stores the

highest and lowest readings since the battery was inserted or since the

RESET button was last pressed.

• The temperature sensor, or probe, is enclosed in a glycol-filled bottle

that is inserted into the location to be monitored, such as inside a

refrigerator or freezer. The thermometer itself can be attached to the

door of the unit with the magnet on the back, or it can be placed on a convenient table or shelf.

• Power to the Thermometer is supplied with one AAA lithium battery. When it is inserted correctly,

all segments of the LCD display are temporarily activated. When the battery needs to be

replaced, a battery symbol will flash on the display.