Manual

10
B5 Check and if necessary adjust the position of the telescopic sight to obtain
the correct eye relief (factory set whenever possible).
B6 Adjust the butt length by adding or subtracting butt spacers to suit the size of
the firer.
FIRING THE RIFLE
CAUTION: Before firing the rifle ensure that solvent, oil or grease has been removed
from the bore. Always use a rod or pull through from the receiver end to
avoid damage to muzzle. Use the rod and rod guide whenever possible.
2C Loading – To load the rifle (Fig 5)
C1 Place a full magazine into the magazine housing
C2 Push the magazine fully upwards until the magazine retaining catch engages
the lug on the magazine.
C3 Open the bolt by raising the bolt handle and pulling it to the rear.
C4 Feed a round from the magazine into the chamber, by sliding the bolt
forward.
ALWAYS CLOSE THE BOLT FULLY
WARNING : FAILURE TO FULLY CLOSE THE BOLT EVERYTIME THE BOLT IS
MANIPULATED, COULD RESULT IN A LIVE ROUND BEING LEFT IN THE
CHAMBER. THE EXTRACTOR DOES NOT ENGAGE THE RIM OF THE
CARTRIDGE UNLESS THE BOLT IS FULLY CLOSED
FIG 5. LOADING
PDF created with FinePrint pdfFactory trial version www.pdffactory.com