Manual

28
13. TORQUE SETTINGS FOR AW RIFLE
Stock side screws 0.8Nm
Shroud cover screws 2.0Nm
Muzzle brake clamp 4.0Nm
Foresight clamp 3.5Nm
Rearsight clamp 3.5Nm
Trigger clamp screws 3.5Nm
Action screws 4.0Nm
Butt pad screws 3.5Nm
Scope to action screws
4mm key 3.5Nm
3mm key 2.5Nm
Scope ring screws 2.5Nm
14. SUPPLEMENT FOR WEAPONS FITTED WITH A SUPPRESSOR UNIT
Cleaning the Suppressor Unit
Important
SUPPRESSOR UNIT MUST BE REMOVED FROM BARREL, BEFORE CARRYING OUT
THIS OPERATION
- Plug one end of the suppressor unit
- Mix up a cleaning solution consisting of 150gms of SODA CRYSTALS to 5 litres of
warm clean water.
- Pour cleaning solution into open end of suppressor unit and leave standing for 30
minutes.
- Empty and flush out until water runs clear.
- Leave standing until thoroughly dry inside and out before refitting to weapon, ensuring
that the barrel thread and location spigot are well lubricated.
PDF created with FinePrint pdfFactory trial version www.pdffactory.com