User manual

DigiScale Manual Part # 800-1404-001 Page 22 of 36
Programming
Several functions of the Digi readout are user programmable. The following
describes what features and functions are available and how to change the
factory defaults to customize your DigiScale system.
To enter Programming Mode:
1. Press and hold the UNITS key then momentarily press the DATUM key.
2. The LCD will briefly display: PG on (Programming On), then
Pr 1, (indicating Programming Parameter #1)
3. Release the UNITS key
4. The value stored in Pr1 is displayed.
Once in the Programming Mode:
Moving up parameter list: Momentarily press the UNITS key to advance
through the Programming Parameter list. The Parameter number is displayed
first, then the current value for the parameter.
Moving down parameter list: Press and hold the ON/OFF key, then
momentarily press the UNITS key to move backward through the
Programming list.
Increase parameter value - Momentarily press the PLUS (+) key while
displaying a Programming Parameter Value to increase the setting.
Decrease parameter value - Momentarily press the MINUS (-) key while
displaying a Programming Parameter Value to decrease the setting.
Reset parameter value to default setting - Momentarily press the DATUM key
while displaying a Programming Parameter Value to reset the parameter to
the factory default value.
Exit programming mode
- Press and hold the UNITS key. Momentarily
depress the DATUM key. The LCD will briefly display: PG oFF (Programming
Off), then return to normal operation.
NOTE: The system will automatically exit programming mode after 60
seconds of no key activity.
Momentarily press
Press & Hold