User manual

Accurate Technology DigiScale Models 18 & 28 User Manual Page 23 of 36
Programming Parameters
The Digi readout programming parameters are listed below.
Values in [ ] are the available range of values that can be entered for that
parameter. Factory defaults are shown in Bold Red.
Pr 1 – Datum Key Value [0 to + 999.999in] or [0 to +9999.99mm]
The programmed value that will be recalled whenever the DATUM key is
pressed during normal operation.
Default = 0.00
Pr 2 – Reading Direction [0 or 1]
This parameter controls the direction of travel (positive vs. negative) when
the encoder is moved.
Default = 0
Pr 3 – Key Lockout [0 or 1]
This parameter controls the operation of the +, - and DATUM keys.
If enabled, (set to 1), these keys will not function and the LOCK
LOCKLOCK
LOCK symbol will
appear on the display. This prevents accidental changes when pressing
these keys during normal operation.
Default = 0
Pr 4 – Resolution [1, 2, 3 or 4]
This parameter sets the number of places to the right of the decimal point on
the readout.
A value of 1 – Low - will display x.x.
A value of 2 – Normal - will display x.xx
A value of 3 – High - will display x.xxx
Default = 3
NOTES:
Millimeters have a maximum of 2 places (even if parameter is set to 3.)
This setting has no effect when displaying fractions.