User`s manual

ProScale M150, M250 and all products with General Purpose LCD Digital Displays 23 of 44
Panel Mount Displays
The General Purpose LCD Display for panel and enclosure mounting applications comes
in two versions. Both are designed to fit a ¼ DIN (90mm x 90mm) (3.5in x 3.5in) panel
opening. One version is battery operated (2D) and the other is designed for 24VDC
operation. Both versions have full programming capability.
Fully Programmable Fully Programmable
2D Batteries 24VDC
SPC output Limit/Monitor Signal Output
LCD Backlighting
P/N 701-1570-100 P/N 701-1560-100
NEW P/N 700-1600-400 P/N 700-1600-300
Fully Programmable, Battery Operation
This display operates on 2D batteries. It has an auxiliary keypad with 6 keys for:
switching between ABSolute readings and INCremental measurements, MONitoring
position drift, SENDing data out the SPC connector, HOLDing the reading and
suspending key press activity, and F1 & F2 special function keys.
This display does not have Limit Alarm / Monitor Output, or Back-Lighting.
Programming Parameters Pr0 through Pr23 are applicable to this display.
Fully Programmable, 24VDC
This display includes all the features of the PROGRAMMABLE Battery display. This
display is intended to operate on 24VDC. It comes with a connector that allows easy
connections for supply voltage and also serves as the output connection for the position
Limit / Monitoring output signal.
Programming Parameters Pr0 through Pr23 are applicable to this display.
Mounting the Panel Mount Display
A cutout should be made in the panel at least 90mm x 90mm (3.6 x 3.6 inches), but no
larger than 93mm x 93mm (3.7 x 3.7 inches)..
The cases of the digital display are designed to "sandwich" panel thicknesses between
3mm (0.125") and 20mm (0.750") between the front and rear display cover.
Note: If Panel is thinner than 3mm (0.125 in), shorter screws must be used for the
display casing or damage to the front cover of the display will occur.