Installation manual

Operation Manual for LCD Digital Readouts Page 16 of 48
PLUS (+) & MINUS (–) KEYS
Momentarily depressing the + or – key increments or decrements the current
displayed value by one unit of measurement.
Pressing and holding the + or – key will cause the displayed value to change
continuously. Continue pressing the key to cause the amount of change to
speed up. This allows for quick adjustments over a large range of values.
These keys may be locked out to prevent accidental offset entries.
See LOCK FUNCTION and Programming Parameter (Pr3).
DATUM KEY
The DATUM key is used to change the currently displayed value.
Momentarily pressing the DATUM key forces the display to a user programmed
value. This can be zero or any other displayable value.
See Programming Parameter (Pr1).
The DATUM key can be locked out to prevent accidental entries.
See LOCK FUNCTION and Programming Parameter (Pr3).
Press and hold the DATUM key for 6 seconds to display the battery voltage.
Press and hold the DATUM key for 9 seconds to display the temperature.
The temperature is displayed in the format “xx.x F” or “xx.x C” where xx.x is the
temperature and the units are in degrees Fahrenheit or degrees Celsius based
on the current measuring units setting (Inch or Metric). The temperature
readout will continue to be displayed until the datum key is released.
Temperature is sampled on startup and every 10 minutes thereafter.
Momentarily or Press & Hold
Press & Hold
Mo
mentarily press