Installation manual

Operation Manual for LCD Digital Readouts Page 34 of 48
Operating the system in compensated mode.
After a successful correction table has been programmed, the DRO will operate
normally and the measuring system will have a higher level of accuracy. If the
encoder is positioned outside the calibrated range of operation, the LCD will
display No Co
No CoNo Co
No Co alternately with the current position. This indicates that the
system is operating outside the calibrated measuring range and has a reduced
measuring accuracy.
If you choose to turn off Non-Linear Compensation (Pr39=0,) the compensation
table will be saved in memory. Changing Pr39 to 1 will re-enable the previously
stored compensation table.
Note: Re-setting the Digital Readout to factory settings does not erase the
compensation table.