Installation manual

Operation Manual for LCD Digital Readouts Page 38 of 48
SECTION 4 PROGRAMMING
Several functions of the Digital Readouts are user programmable. The
following describes what features and functions are available and how to
change the factory defaults to customize your Digital Readout.
To enter Programming Mode:
1. Press and hold the UNITS key then momentarily press the DATUM key.
2. The LCD will briefly display: PG on
PG onPG on
PG on (Programming On), then
Pr 1
Pr 1Pr 1
Pr 1, (indicating Programming Parameter #1)
3. Release the UNITS key
4. The value stored for Pr1 is displayed.
Once in the Programming Mode:
Moving up parameter list - Momentarily press the UNITS key to advance through
the Programming Parameter list, first displaying the Programming Parameter
number then the currently programmed value.
Moving down parameter list - Press and hold the ON/OFF key and momentarily
press the UNITS key to move backward through the Programming Parameter
list.
Increase parameter value - Momentarily press the PLUS (+) key while displaying
a Programming Parameter Value to increase the parameter setting.
Decrease parameter value - Momentarily press the MINUS (-) key while
displaying a Programming Parameter Value to decrease the parameter setting.
Reset parameter value to default setting - Momentarily press the DATUM key
while displaying a Programming Parameter Value to reset the parameter to the
factory default value.
Exit programming mode - Press and hold the UNITS key. Momentarily depress
the DATUM key. The LCD will briefly display: PG oFF
PG oFFPG oFF
PG oFF (Programming Off),
then return to normal operation. NOTE: The system will automatically exit
programming mode after 60 seconds of no key activity.
Momentarily press
Press & Hold