Installation manual

Operation Manual for LCD Digital Readouts Page 8 of 48
Digital Readout Specifications
Linear Measurements:
Display Ranges: + 999.999 in; + 399 63/64 in
+ 9999.99 mm; + 999.999 cm
Resolution:* .1inch .1mm .1cm or
.01inch .01mm .01cm or
.001inch .01mm .001cm or
.0005inch .01mm .001cm
Repeatability: .001in or .01mm or .001cm
Temperature Measurement:
Accuracy: + 1º C from 0 to 70º C, + 2º C otherwise.
Resolution: .1º C
Operating Power:
Basic: 2 AA Batteries
General Purpose: 2 AA Batteries or 9-24VDC
Panel Mount: 1 CR123 3V Lithium Battery or 24VDC
Operating Temperature: 32 to 120°F, 0 to 50°C
Output:
Basic: None
General Purpose: Mitutoyo Digimatic® SPC
Panel Mount: Mitutoyo Digimatic® SPC
* Position data displayed on the LCD and sent to the SPC port is auto-ranging.
This means that the defined resolution may be temporarily overridden by the
system if the position to be displayed or sent exceeds the allowable maximum
position for that resolution. In that case, the system will continue to reduce the
resolution until either an allowable resolution is achieved or to 1 decimal place
to the right of the decimal point. Maximum displayable values are:
Inch Resolution Maximum Value (Inches)
4 decimal places 99.9999
3 decimal places 999.999
2 decimal places 9999.99
1 decimal place 99999.9
Millimeter Resolution Maximum Value (mm)
2 decimal places 9999.99
1 decimal place 99999.9
Table 1.1 Maximum Resolution