Instruction manual

Note: Locking the keypad may cause the PLUS and MINUS keys to

function differently. (See “Pattern Adjustment”.) The zero key

will not function when the display is locked.

Pattern Adjustment (Basic Display Only)

Whenever the readhead is disconnected from its power source, or the

display is turned off, and the readhead is moved over a pattern joint, the

displayed reading may be one or more patterns (+ 430mm) in error when

power is restored. This may also occur if the readhead is moved too

quickly in Model 150/250 systems.

To correct the error, place the digital display in ABS LOCK mode and

use the PLUS or MINUS keys to increment or decrement the reading

until the proper reading is displayed. Using this procedure will result in

NO LOSS OF ACCURACY to the system.

Changing the Batteries

To change the batteries, remove the two screws holding the cover to the

base of the display housing. Carefully pull off the cover. Remove the

batteries. Reinstall new ones, noting the proper orientation shown in the

battery compartment. Replace the cover and tighten the screws.

Note: DO NOT ATTEMPT TO BEND BATTERY CLIPS!

Mounting the Display

There are four small mounting holes in the back of the display which may

tapped for M2 or 4-40 screws. The display may also be mounted using

double sided tape or Velcro.