User manual

ProScale RF Receiver User Manual Page 14 of 17
Baud Rate
To display the current baud rate (from default), type in:
b<ENTER>
The receiver responds with:
Baud rate = 9600
To change the baud rate to 19200, type:
B19200<ENTER>
The receiver responds with:
Baud rate will be = 19200
The baud rate change becomes effective 1 second after the command is issued
to allow the change message to be sent at the old baud rate.
Available baud rates are:
• 2400
• 4800
• 9600
• 19200
• 38400
• 57600
• 115200
Firmware Version ID
To display the current firmware version, type in:
v<ENTER> or V<ENTER>
The receiver responds with:
ProScale Receiver V1.xxx
Where xxx is the minor revision number.
If an invalid command letter is entered, the receiver will provide the following
response:
Use t, s, o, d, v, b, m or e.
Upper case to edit, lower case to view.