User`s manual

Accurate Technology ProScale Page 22 of 48
Display Installation
Surface Mount Display
The SURFACE MOUNT General Purpose Display may be mounted:
• Using Velcro or Double sided tape
• Drilling out any of the four holes from the inside of the case
• Using any of the six holes on the back of the case which may tapped for
M2 or 4-40 screws.
NOTE: Care must be taken when using the inside holes. If using the
lower left hole as shown above, be sure to use a screw that will not rise
above the extruded countersink as this may short the input connector.
Panel Mount Display
A cutout should be made in the panel at least 90mm x 90mm (3.6 x 3.6
inches), but no larger than 93mm x 93mm (3.7 x 3.7 inches).
The cases of the Display are designed to "sandwich" panel thicknesses
between 3mm (0.125") and 20mm (0.750") between the front and rear
Display cover.
NOTE: If Panel is thinner than 3mm (0.125 in), shorter screws must be
used for the Display casing or damage to the front cover of the Display
will occur.