User`s manual

ProScale M150, M250 with LCD Digital Displays Page 43 of 48
Programming Summary
Factory
Parameter Function Default THIS SYSTEM

Pr0 Reading Direction 0 ______
Pr1 Segment Offset 1 - On ______
Pr2 High Speed ReadHead 0 - Off ______
Pr3 Zero, Offset Entry 1 - Enable ______
Pr4 Display Resolution 1 - Normal ______
Pr5 mm or cm 0 - mm ______
Pr6 Fractions, mm, in 0 - all ______
Pr7 Scaling 1.0000 (none) ______
Pr8 Auto off 15 - 15 min. ______
Pr9 Auxiliary Keypad 7 - all keys ______
Pr10 Offset Addition 0 - disabled ______
Pr11 Offset Addition 1 1.000 Inch ______
Pr12 Offset Addition 2 1.500 Inch ______
Pr13 Offset Addition 3 2.000 Inch ______
Pr14 Output Mode 0 - off ______
Pr15 Output Polarity 0 – Normally Open ______
Pr16 Lower Limit 0.000 ______
Pr17 Upper Limit 5.000 Inch ______
Pr18 Drift Tolerance .010 Inch ______
Pr19 Auto Monitor ON 0 - disabled ______
Pr20 Auto Monitor OFF 0 - disabled ______
Pr21 Auto Monitor Distance .500 Inch ______
Pr22 Backlight On 4 - Always ______
Pr23 FUTURE FEATURE 1 ______
Pr24 RF Display Address 0 – Off ______
Pr25 RF System ID 0 ______
Pr26 Noise Suppression 0 – Minimum ______
Pr27 * Accuracy Comp. Enable 1 – ON ______
Pr28 * Compensation Multiple 5 – 5 in. ______
* Pr27 and Pr28 are only operational with a special version of Firmware.
ProScale Display units that support the Compensation feature have a “C” at
the end of the firmware revision ID. (The Firmware Version is momentarily
displayed on power-up).
Pressing and holding the ON/OFF key and MODE key for 10 seconds
with power off will perform a full segment LCD test AND set all
Programming Parameters to factory defaults.
Note: Defaulting the display to factory defaults will NOT erase the
compensation table.