Specifications
Chapter 1 – Introduction
☆
Disk has bad sector (replace the failed disk with another disk)
☆
Fan Fail (Contact with Accusys product support center)
☆
No battery (Contact with Accusys product support center)
☆
Power ON Channel 1 Fail (Call or email Accusys product support center)
☆
Power ON Channel 2 Fail (Call or email Accusys product support center)
Rear view
Connector for SATA interface
cable
RAID level configuration jumper
pins
Power connector
3-pin RS232 connector (Terminal
port)
Cooling fan vent
The SATA cable is the route used for reading and writing to the array.
The power connector supplies power to the controller box. In order to provide stable power,
we recommend to connect both power connectors on the RAID box.
The 3-pin RS-232 cable is used for remote monitoring of ACS-75170. The RS-232 port is
configured with DTE and PC compatible pin assignments.
There is a triangular symbol “▲” on both PCB connector and RS-232 cable connector,
please make sure you connect in the right direction (both triangle symbols match each
other). Connecting in wrong direction will not damage RAID controller, however the terminal
or GUI will not work.
The cooling fan inside the RAID box provides air circulation for the disk drives.
DO NOT change the RAID level configuration jumpers. They have been set
and ready for use when the controller is delivered.
11