Owner's manual

Accusys 76500/76510

Setting configurations

The master / slave configurations are set manually by placing jumper heads on the nine

jumper pins on the rear of the RAID box (Only for ACS-76500).

Master and slave settings enable your computer to distinguish two IDE/ATA

devices operating on the same channel. In this case, the settings distinguish

ACS-76500 from your computer’s hard disk drive.

It makes little difference which setting you use, but if using master or slave,

you must make sure that the two devices’ settings are different. So, if the HDD

is configured as the master drive, ACS-76500 should be configured as slave,

and vice versa.

Master configuration

1. Make sure the power is turned off.

2. Place one jumper cap over the central

and right master/slave configuration

jumper pins.

Slave configuration

1. Make sure the power is turned off.

2. Place one jumper cap over the central

and left master/slave configuration

jumper pins.