Manual

Chapter 4 – Setting up an array

To connect to the host:

1. Power on ACUTA 4/4S and follow the

instructions earlier in this chapter to

establish a RAID array.

2. Connect one end of an SATA cable to the

SATA port and the other end to a spare

SATA port on your host computer.

If the SATA port of the host computer is embedded in the motherboard, use the

SATA external port cable with bracket to convert this SATA port into an

external port. You will then be able to connect ACUTA 4/4S4 directly to the

host computer.

Advanced users wishing to remotely monitor the status of their array should

connect ACUTA 4/4S via an RS-232 cable to a terminal or computer hosting a

terminal emulation program.

3. The host computer should detect the presence of the ACUTA 4/4S subsystem. Turn to the

next chapter for instructions on formatting your array.

註解 [V18]: replaced the

photo