Manual

Accusys Acuta User’s Manual
44
6. Right click on the disk representing the
array and select Create Partition. Follow
the wizard to create one or more partitions
on the array.
7. When you have completed creating a
partition, the array will appear as a disk in
the disk management section of the
Computer Management dialog box.
Partitioning the array - Linux
The array must be partitioned before it can be used. To do this on a Linux operating system:
1. Establish the array and connect to the host
computer following the instructions in the
preceding chapter. Make sure no error
messages are showing on the LCD display.
2. Turn on the host computer.
3. Check to confirm the operating system has
detected the array: type “df”
The array will be listed as shown at a
temporary location (/tmp). The code given
the array depends on the host interface
type. Arrays connected through a USB or
IEEE 1394 interface will be assigned a
code sda (sdb, sdc etc.). Arrays
connected through a serial ATA interface
will be assigned a code hde (hdf, hdg etc.)
as in the example shown.
When you have confirmed that the array
has been detected: